Can EasyDMM support multiple instrument connections?
September 10, 2019
Yes. EasyDMM can support multiple instruments, but it can only actively measure on one instrument at-a-time. Simply add instruments using the Add Instruments interface. Here, we show 3 active SDMs connected via LAN: NOTE: Mode must be switched to Measure or Scan before data can be collected on the selected instrument.
EasyDMM First Use
August 27, 2019
SIGLENTs EasyDMM software provides easy instrument control and data collection. In this note, we will show how to configure EasyDMM for the first time. Download and install EasyDMM. You can find the download instructions and files here: DMM Software 2. Connect the SDM to the controlling computer or network. The SDMs have USB and LAN connections. … Continued
SDM Power On Last Settings
August 27, 2019
The SIGLENT SDM series of multimeters has a Power On Last function that recalls the last instrument configuration settings used previous to a power cycle. For example, if you have the meter in ACV mode with fixed range, and power cycle the instrument, it will power on in ACV mode with fixed range. The instrument … Continued
Currently supported instruments for use with the SIGLENT USB-GPIB adapter
July 26, 2019
The SIGLENT USB-GPIB adaptor currently works with the following SIGLENT instruments: Multimeters – SDM3065X/SDM3065X-SC SDM3055/SDM3055-SC SDM3045X Function/Arbitrary waveform generators – SDG6000X Series SDG5000 Series SDG2000X Series SDG1000X Series SDG1000 Series Spectrum & vector network analyzers – SSA3000X Series SVA1000X Series Oscilloscopes – SDS1000CFL
USB host connector power limits for instrumentation
June 14, 2019
SIGLENT instruments with USB ports can supply 500mA steady current at 5 V.
USB Connectivity Checklist
February 28, 2019
The Universal Serial Bus (USB) is very popular and has added a tremendous level of convenience and flexibility to computer and peripheral controls, including test and measurement instrumentation. As with all technology, it isn’t always sunshine and blue skies. Here are some common troubleshooting steps for USB connection issues: – Is the instrument plugged in … Continued
Where do I find environmental, EMC, and other compliance information for your products?
February 15, 2019
Information regarding product compliance is available on the datasheet for each product. Contact your local Siglent office for more details if you have trouble finding what you need. You can also write info-eu@siglent.com
SDM ranging in current measurement modes
December 18, 2018
The SDM series of multimeters have autorange capabilities that allow the meter to automatically select the range appropriate for a given input signal level. To prevent damage to the meter, current (ACI and DCI measurement modes) ranges will be automatically up-ranged if the input signal exceeds the maximum value for the selected manual range. In … Continued
Dual measurement connections for voltage, period/frequency and current measurements for SDM3000 series DMMs
November 14, 2018
The SDM3000 series of Digital Multimeters feature dual measurement capability. This means that the instrument can alternate between two measurements and simultaneously display both values. Here are the functions that qualify for dual measurements: Here is an example of the display of an SDM measuring DCV and DCI using the dual measurement technique: … Continued
What instruments accept SCPI commands for remote control?
October 25, 2017
All SIGLENT instruments (except for the SHS1000 and SHS800 hand-held oscilloscopes) support SCPI remote control commands. For more information, download the specific instrument programming guide located on the product page.