Operating Tips

SDS6000A Series

SIGLENT Serial Number Format

September 1, 2022

Starting in 2017, SIGLENT has been using this format for serial numbers for instrumentation:

August 22, 2022

The SIGLENT SDS2000X Plus, SDS2000X HD, SDS5000X, and SDS6000A series of oscilloscopes feature trace labels that can be edited by the user. This can make it much easier to differentiate traces on the display as well as in saved images of the display for reporting, etc.. In this tip, we will show you how to … Continued

SDS6000A Typical Noise Floor

June 24, 2022

Here are the typically expected noise floor numbers for the SDS6000A Oscilloscope: Note: Uses StdDev measurement @ 5 GSa/s, 10 MPts/ch

Common Fuse Information

February 24, 2022

Fuses are a common circuit element and are key to protecting from overvoltage and overcurrent situations that can damage important circuits. Fuse markings are typically stamped symbols located on the metal cap of the fuse. Here is a helpful guide to common fuse markings used with instrumentation, taking a common fuse type as an example: … Continued

Cross-reference of Oscilloscope Serial Decoding equivalents to Tektronix MDO3 packages

December 3, 2021

Here is a cross-reference of SIGLENT oscilloscope serial decoding features compared to the Tektronics MDO3 options: Tek MDO3MSO: 16 channel logic analyzer function. The SIGLENT equivalent is optional license SDSxxxx-16LA, where xxxx represents the model (SDS1000X-E, SDS2000X-E, SDS2000X Plus, SDS5000X, or SDS6000A series of oscilloscopes) and hardware (SPL2016 for SDS2000X Plus, SDS5000X, and SDS6000A series/SLA1016 … Continued

Do your instruments support UDP communications over LAN?

August 5, 2021

Not at this time. Many instruments support communication via sockets (port 5025) and telnet (port 5024) but the port numbers cannot be changed. If you use VISA, you can implement LAN via TCP/IP, which does not need a port number. Here is a listing of current SIGLENT instruments with Socket and Telnet Support.

Bode plot memory depths

July 19, 2021

Here is a table showing the various memory depths used in the Bode Plot feature Product series  Max memory depth  SDS1xx4X-E   140k  SDS2000X-E  140k  SDS2000X Plus  100k  SDS5000X 125k

Why is the Bode Plot start frequency minimum 10 Hz?

June 23, 2021

The minimum start frequency is set to 10 Hz because of the extended acquisition time required to collect enough data to ensure a useful level of measurement accuracy. If the low limit was 1 Hz, the scope would need to test 10 cycles (to maintain specified accuracy), so the time base will be 10 s/div. … Continued